COPYSTAR CS 3035 DRIVER

Page Machine cross section Switchback unit Paper path Figure Drives upper drawer lift. Also to clear the service call code counts after replacing consumable parts. Dirty drum separation claws. U Setting the fixing phase control Description Sets the use of fixing phase control to reduce electr i cal noise generated by the copier.

Uploader: Kaganos
Date Added: 13 June 2009
File Size: 67.17 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 6158
Price: Free* [*Free Regsitration Required]

When using copystar cs-3035 extension cable, always check that ccopystar is adequate for the rated current U Checking shading Description Performs scanning under the same conditions as before and after shading is performed, displaying the original scanning values at nine points of the copystar cs-3035 glass. Page Intermediate tray section The intermediate tray section consists of the components shown in Figure The height of the magnetic brush is regulated by the doctor blade; Page 3 Adjusting the center line of copystar cs-3035 printing Make copystar cs-3035 following adjustment if there is a regular error between the center lines of the copy image and original when copying using the duplex unit.

Copystar CS3035 Toner Cartridges

copystar cs-3035 Deformed or worn cleaning blade. Also check for continuity copystar cs-3035 the C-3035 message safety switch connector connector cable.

Got it, continue to print. Figure Procedure Upper left cover All the LEDs on the operation panel light.

Copystar cs-3035 operation unit of the copier shows a jam message and the jam location. To reset the paper misfeed detection, open and close the desk left cover to turn the copystar cs-3035 safety switch off and on.

Tap the top of the toner container five to six Toner container times. Trailing copystar cs-3035 registration motor TERM. Copystar cs-3035 the P connector of the paper feed desk into the connector on the copier.

Open the deck side cover.

copystar | eBay

Safety cppystar This booklet provides copystar cs-3035 warnings and precautions for our copystar cs-3035 personnel to ensure the safety of their customers, their machines as well as themselves during maintenance activities. Copystar PF70 Paper Supply: Insert the connector of the drawer heater into Power source PCB unit the connector of the machine.

Clean the main charger wire, grid and shield. If the switchback unit has been installed, connect the signal cable of the switchback unit, as well.

Purpose To be executed after replacing the scanner unit or installing the network scanner board. Push the drum separation claw assemblies with the minus copystar cs-3035 copystsr the top of the corner hole and remove the claw assemblies. Purpose To change the setting according to the type of the fixing unit. Harness the power of Copystar MFPs with customized business apps that turn your otherwise complex workflows into copystar cs-3035 processes.

Copystar CS-3035 Service Manual

copystar cs-3035 Purpose According to user request, sets or cancels restriction on the number of sheets. The stapler motor STM drives the stapler cam via the stapler drive gear to staple paper.

Read More December 12, Reduce costs and improve workflows with Copystar’s Total Document Solutions. Page 4 Adjusting the position of the center adjuster center line copystar cs-3035 Perform the following adjustment if the center lines of the copy image and the copy paper are misaligned.

Copystar cs-3035 the shield cover into place with 13 screws.

All Listings filter applied Two leaders in their fields combine expertise to bring Business Process Improvement to a whole new level. Purpose To check if all the LEDs on the operation panel light.

To copystar cs-3035 this problem, the cs-035 position should be changed so that shading is possible without being affected by the copystar cs-3035 or stains.